Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateClopay Cable & Drum Replacement: The Mesquite Owner’s Guide
We replace Clopay-compatible cables and drums for Mesquite homeowners, and the typical installed cost runs $130 – $250 for cable work, with a pair of drums and a fresh cable set landing toward the middle of that range. Cable and drum failures are quick to diagnose, and we can usually get to them the same day you call. Fans of Fernbrook Garage Door Repair Mesquite handle the call live, 24 hours a day, seven days a week.
Most owners don’t know the part’s name until it fails. You pull into the driveway on a 108-degree July afternoon and the door hangs crooked, one side higher than the other. Or you hear a sharp snap from the garage, then a door that won’t lift past the first few inches. Sometimes it’s quieter: a cable that’s started to fray and curl off the drum, visible when you look up at the top corners of the door. In Mesquite, the dry heat and blowing desert grit wear on cables and drums faster than most people expect, and the first sign is usually a door that moves unevenly or a cable that’s lost its tension.
Which Clopay Models This Applies To
Clopay makes a wide range of residential doors under several lines, and the cable and drum setup is different across them. The most common Mesquite setups are Clopay’s steel raised-panel doors and carriage-house styles, and the part you need depends on door height, weight, and the track radius your door was built with.
Here’s the compatibility gotcha most homeowners miss: Clopay drums come in different cable-groove sizes depending on door weight and spring type. A standard 7-foot door with a torsion spring and a 7-foot door with extension springs use different drum configurations, and swapping in the wrong drum will cause the cable to track off the spool. The drum number is usually stamped on the drum itself, and there’s a door label on the inside of the top section. If the label is faded or painted over (common in Mesquite’s sun-baked garages), we measure the door height, cable diameter, and drum profile before we order anything.
We work with OEM Clopay-compatible drums and quality aftermarket equivalents. The aftermarket option costs less and holds up well in this climate, provided the fitment matches. We won’t put a part in that we wouldn’t stand behind for the long haul, and we say plainly which part we’re installing before any work starts.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Clopay Cable & Drum Replacement Is Failing
These are the symptoms we see most often on Clopay doors in Mesquite. Each points to a different root cause, and some are more urgent than others.
- The door hangs crooked. One side drops lower than the other. Usually a cable that’s slipped or snapped on one side, or a drum that’s no longer spooling evenly.
- A visible fray or curl on the cable. Look at the cable that runs from the bottom bracket up to the drum. Frayed strands and a kinked cable mean it’s near the end of its life and shouldn’t be cycled.
- A loud snap, then a door that won’t move. Classic cable failure. The spring torque releases suddenly when the cable lets go, and cycling the door again can cause the door to come off track.
- Grinding or a cable rubbing sound. The cable is riding off the drum groove or the drum is worn. Mesquite dust and grit accelerate this, especially on doors facing the open desert.
- A loose, slack cable on one side. Tension is gone, and the door is being carried by the springs alone. That’s a stop-and-call situation, not a wait-and-see.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Mesquite, Clopay cable replacement runs $130 – $250 installed. Drum replacement, when both drums and the cable set are replaced together, lands inside the same range or just above it, since drums are sold as a pair. The honest number comes from what we find when we measure the door: cable diameter, door weight, drum profile, and whether the bottom brackets or springs need attention at the same time.
Our cable and drum work is part of the broader garage door repair range of $150 – $600, because a full repair sometimes includes brackets or spring work that we didn’t know about until we had the door open. That’s why we don’t quote over the phone from a guess. A written price comes before any work begins, every visit, and it doesn’t move once you agree to it.
Every cable and drum job is covered by our 365-Day Done Right Promise. If something isn’t right, we make it right. That’s stamped on the job, no negotiation needed.
DIY or Call Us?
We’ll be direct, because this is one of those parts where DIY goes wrong in a hurry. Cables and drums sit under spring tension, and the torsion spring holds enough stored energy to cause serious injury if it releases while you’re working on the cable. There’s no safe way to release that tension without the right winding bars and training. We recommend a trained technician for anything involving the cable, drum, or spring assembly. If you’re not sure whether the cable is the problem, a quick visual from outside the door (look for fraying or a crooked hang) is fine. But once you see a snapped or slack cable, stop cycling the door and call us.
That call goes to a live person at (888) 255-7680, day or night. Our technicians have up to 24 years of experience, and we’re trained on Clopay alongside liftMaster, Chamberlain, and Genie systems, so we know how these doors are built. Fernbrook Garage Door Repair Mesquite is an independent service provider and isn’t affiliated with Clopay.
FAQs
In Mesquite’s heat and dust, expect a cable set to last 6 – 10 years and drums to outlast the cable by a few years. Doors facing west or the open desert tend to wear faster because the cable and drum see more heat and grit. If your door is over ten years old and one cable has failed, the other is likely close behind, and replacing the pair together saves you a second service call.
No, a frayed or snapped cable has to be replaced. A cable that’s showing broken strands has lost its strength, and there’s no safe way to repair it in place. We replace the cable and inspect the drum and bottom bracket at the same time, since a bad drum is often what caused the cable to fail. Call (888) 255-7680 for a free estimate.
A single cable replacement takes about an hour, and a full drum-and-cable set runs closer to two hours. We protect the inside of your home with shoe covers and drop cloths, and we ask before we move anything near the door. We’ll also text or call if you need quiet tools during nap time or school hours. Call (888) 255-7680 and we’ll give you a written price before we start.
We match the part to your door using the drum stamp and door label, and we measure the door if the label is worn. We work with OEM Clopay-compatible drums and quality aftermarket equivalents, and we tell you which one we’re installing. Parts are ordered to your door’s spec, not pulled from a shelf hoping for the best. Call (888) 255-7680 for a free estimate and we’ll walk you through the options.
Written by the team at Fernbrook Garage Door Repair Mesquite, serving Mesquite and nearby areas.