Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateGenie Cable & Drum Replacement: The Mesquite Owner’s Guide
We replace Genie-compatible cable and drum sets for Mesquite homeowners, and the typical installed price runs $130 – $250 depending on the model and how much of the drum assembly has to be replaced. Cable and drum work is a same-day repair in most cases when you call in the morning. You’ll usually find out this part has failed the same way everyone else does: the door comes down crooked, the cable hangs loose along one side, or you hear a loud pop from the garage and the door won’t lift at all.
Which Genie Models This Applies To
Genie sold a lot of doors and openers in Mesquite, and the cable and drum setup varies by what’s actually on your door. The drum is part of the door, not the opener, so the model number on your Genie opener doesn’t automatically tell us which drum you have. What matters is the door: how tall it is (7-foot and 8-foot are the common residential sizes), the track and panel arrangement on your specific door, and the shape of the drum. To identify the right part, look for a label on the door panels or a stamp on the drum itself. If there’s no label, we measure the door height, the drum diameter, and the cable gauge. A particular gotcha on Genie setups: some drums are handed left and right, and mixing them up looks fine until the door is cycled and the cable jumps the groove.
On the OEM-versus-aftermarket question: Genie-branded replacement parts can be harder to source for older doors, and a quality aftermarket drum and cable set is a normal, safe substitute when the specs match. We’re an independent service provider and not affiliated with Genie, so we’re not locked into one parts channel. If you’ve been told a Genie cable and drum set is no longer available for your door, that’s worth a second look. We also service LiftMaster and Chamberlain doors, but this page is specific to Genie.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Genie Cable & Drum Replacement Is Failing
- The door comes down crooked. One cable is stretched or slipping off its drum, so it lifts and lowers at a different rate than the other side.
- A cable hangs loose or is frayed. Strands break one at a time over the years, and a frayed cable means the drum is likely out of alignment or worn.
- You hear a pop, then the door won’t open. The cable has come off the drum or snapped. Don’t force the opener – stop and call, because a cable under tension can whip.
- The drum spins but the door doesn’t move. The cable has come loose from the drum groove, so the drum turns without any load on it.
- Grinding or scraping from one side. A worn drum or a cable dragging its groove. The metal-on-metal sound usually means the drum needs replacing, not just the cable.
In Mesquite, the dry desert air and big temperature swings between summer afternoons and cool nights work on the cable strands and the drum metal. We see more fraying and seized drums on doors that face the afternoon sun than on shaded doors.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Cable repair in Mesquite runs $130 – $250 installed, and that range covers the cable and drum set, the labor, and a check of the spring and track while we’re in there. What pushes a job toward the top of the range: a full drum replacement instead of cable only, an 8-foot door, or a door that also needs track realignment ($120 – $240). General garage door repair sits at $150 – $600 if your door has more than one issue going on.
The price is written down and agreed before any work starts, every visit. That written price includes background-checked, uniformed technicians, shoe covers and drop cloths inside the home, and a photo of the clean-up before we leave. Every job is stamped with the 365-Day Done Right Promise.
DIY or Call Us?
Here’s where we’ll be honest with you: a cable and drum is high-tension equipment, and this is not a safe DIY repair. The cable is held under load by the spring system, and if it’s cut or released without the spring tension taken off first, the cable can whip with enough force to cause serious injury. You can safely do two things: look at the door from a few feet back and note which side is crooked, and check that the door is fully closed before you call. Beyond that, this is a trained-professional job.
If you call, we’ll tell you what we think it is, whether it’s likely a cable or drum, and what it will cost. Call (888) 255-7680 and a live person answers any hour.
FAQs
How long does a Genie cable and drum set last? A typical cable and drum setup lasts somewhere around 10,000 to 15,000 door cycles, though Mesquite’s heat and dry air can shorten that on doors facing the sun. Years of cycles, not calendar time, is the better measure.
Can the cable be repaired instead of replaced? No. A frayed or stretched cable isn’t a repair candidate; it’s a replacement. A worn drum also gets replaced, not patched, because a damaged groove will keep wearing through new cable.
How long does the swap take? Most Genie cable and drum replacements take about an hour to an hour and a half once the correct part is on site. If a drum has to be ordered, that’s the only thing that can stretch it to a second visit.
How do you source the part? We match the drum and cable to your door’s measurements and existing drum shape, then source the correct-spec part. If a Genie-branded part isn’t available for your door, we use a quality aftermarket equivalent that matches the specs, and we tell you which part you’re getting before we install it.
Questions about what’s going on with your Genie door, or ready to get a written price? Call (888) 255-7680 for a free estimate. We’ll come out, measure the door, show you the worn part, and put the price in writing before we touch a tool.
Written by the team at Fernbrook Garage Door Repair Mesquite, serving Mesquite and nearby areas.